SMART fortwo coupe Owner's Manual page 102

On-board computer and displays
100
X
Briefly press the OK button on the control
lever.
X
Press the control wheel on the control
lever up or down until the desired
minutes have been selected.
X
Briefly press the OK button on the control
lever.
X
Press the control wheel on the control
lever up or down until the "Adj. temp. for
depart" function has been switched on or
off.
X
Briefly press the OK button on the control
lever.
The new departure time is stored and
activated.
The "Adj. temp. for depart" function is
switched on or off.
Starting high-voltage battery charging
directly
Use this function to start the charging
process directly. Charging begins as soon
as the charging cable is connected.
i
Charging also starts when you plug the
charging cable into the vehicle socket.
However, this only applies if you have not
preset a departure time.
For information about the charging
process, see (
X
Press the control wheel on the control
lever up or down until the
charge
menu appears in the multifunc-
tion display.
X
Briefly press the OK button on the control
lever.
Charging begins as soon as the charging
cable is connected.
i
If you call up the
you will not be able to use the "Adj. temp.
for depart" function.
Y
page 79).
Instant
Instant charge
Setting the maximum possible charge cur-
rent
G
WARNING
If the charge current draw via a mains
socket is too high during the charging
process, the external mains supply may
overheat. There is a risk of fire.
Before charging, check the maximum per-
missible charge current available at the
location. If necessary, contact a qualified
specialist company for assistance.
Adjust your vehicle's settings, if neces-
sary.
! If the charge current is too high, the
fuse could be tripped or the external
mains supply could overheat. Check if the
external mains supply is equipped to
handle the programmed charge current.
If necessary, reduce the programmed
charge current or use a different mains
socket.
You can limit the charge current used for
charging the high-voltage battery. This
may protect the mains supply from over-
loads. You can set the limitation either on
the charge cable control panel or via the
on-board computer (
The default value is "Max." This is the max-
imum charge current available from the
mains supply.
Before charging the high-voltage battery,
check the maximum permissible charge
current for the particular mains socket.
The following values are available: 8 A,
12 A, Max. The last value set will be stored
until you change it again.
X
Press the control wheel on the control
menu,
lever up or down until the
rent
menu appears in the multifunction
display.
X
Briefly press the OK button on the control
lever.
Y
page 80).
Charge cur‐