Advertisement
d) Route the cable through the notch and attach
the rear right cover. (Two screws)
b. When the ferrite core is installed to the sup-
plied modular cable
(1) Connect the supplied modular cable in the mod-
ular jack (LINE) of the fax kit (Line 1).
Note:
If the user is connected with a key telephone sys-
tem or a private branch exchange (PBX), do not
connect the modular cable to where other than an
analog line.
(2) Following the steps given below, house the fer-
rite core of the modular cable in the machine.
a) Hook the cable.
b) Pass the cable wound around the ferrite core
through the protrusion.
a
b
<Only when using the telephone line>
(3) Perform the following steps.
a) Attach the supplied ferrite core to the position of
the modular cable of the telephone shown in
the illustration.
Note:
Install the ferrite core by winding the cable two
turns.
Fax kit connection side
80 ± 5 mm
b) Connect the modular cable of the telephone
line to the modular jack (TEL) of the fax kit
(Line 1).
E-6
Advertisement
