Advertisement
<Only when using the telephone line>
(2) Insert the modular cable of the telephone line to
the modular jack (TEL) of the fax kit (Line 1).
<Only when installing line 2>
(3) Insert the supplied modular cable in the modular
jack (LINE).
Note:
If the user is connected with a key telephone sys-
tem or a private branch exchange (PBX), do not
connect the modular cable to where other than an
analog line.
(4) Place the modular cable in the harness guide.
<When adding no paper feed options/desk or when
using the Desk DK-705>
(5) Pass the modular cable into the hole in the lower
portion of the rear right cover.
<When using the Paper Feed Cabinet PC-415/PC-
215/PC-115 or desk DK-510>
(5) Perform the following steps.
a) Remove the rear right cover from the paper
feed cabinet or the desk. (Two screws)
b) Remove the knockout from the rear right cover
using nippers.
c) Route the modular cable through the three wire
saddles.
E-5
Advertisement
