Advertisement
b) House the ferrite core of the modular cable in
the machine.
Note:
Pass the cable wound around the ferrite core
through the protrusion.
Protrusion
(5) Route the modular cable through the harness
guide.
<When adding no paper feed options/desk or when
using the Desk DK-705>
(6) Pass the modular cable into the hole in the lower
portion of the rear right cover.
<When using the Paper Feed Cabinet PC-410/PC-
210/PC-110 or desk DK-510>
(6) Perform the following steps.
a) Remove the rear right cover from the paper
feed cabinet or desk. (Two screws)
b) Remove the knockout from the rear right cover
using nippers.
c) Route the modular cable through the three wire
saddles.
E-14
Advertisement
