Advertisement
<Only when using the telephone line>
(3) Perform the following steps.
a) Attach the supplied ferrite core to the position of
the modular cable of the telephone shown in
the illustration.
Note:
Install the ferrite core by winding the cable two
turns.
Fax kit connection side
80 ± 5 mm
b) Connect the modular cable of the telephone
line to the modular jack (TEL) of the fax kit
(Line 1).
c) House the ferrite core of the modular cable in
the machine.
Note:
• Pass the protrusion shown in the illustration
below through the cable wound around the fer-
rite core in step a).
• Position the ferrite core so that it is placed on
the base shown in the illustration below.
Protrusion
Base
<Only when adding LINE-2>
(4) Perform the following steps.
a) Connect the supplied modular cable in the
modular jack (LINE) of the fax kit (Line 2).
Note:
If the user is connected with a key telephone sys-
tem or a private branch exchange (PBX), do not
connect the modular cable to where other than an
analog line.
E-13
Advertisement
