HP MSR2003 Configuration Manual page 209

[P] multicast routing
[P-mrib] quit
# Configure an MPLS LSR ID, and enable the LDP capability.
[P] mpls lsr-id 2.2.2.2
[P] mpls ldp
[P-ldp] quit
# Assign an IP address to the public network interface GigabitEthernet 2/1/1, and enable
PIM-SM, MPLS capability, and LDP capability on the interface.
[P] interface gigabitethernet 2/1/1
[P-GigabitEthernet2/1/1] ip address 192.168.6.2 24
[P-GigabitEthernet2/1/1] pim sm
[P-GigabitEthernet2/1/1] mpls enable
[P-GigabitEthernet2/1/1] mpls ldp enable
[P-GigabitEthernet2/1/1] quit
# Assign an IP address to the public network interface GigabitEthernet 2/1/2, and enable
PIM-SM, MPLS capability, and LDP capability on the interface.
[P] interface gigabitethernet 2/1/2
[P-GigabitEthernet2/1/2] ip address 192.168.7.2 24
[P-GigabitEthernet2/1/2] pim sm
[P-GigabitEthernet2/1/2] mpls enable
[P-GigabitEthernet2/1/2] mpls ldp enable
[P-GigabitEthernet2/1/2] quit
# Assign an IP address to the public network interface GigabitEthernet 2/1/3, and enable
PIM-SM, MPLS capability, and LDP capability on the interface.
[P] interface gigabitethernet 2/1/3
[P-GigabitEthernet2/1/3] ip address 192.168.8.2 24
[P-GigabitEthernet2/1/3] pim sm
[P-GigabitEthernet2/1/3] mpls enable
[P-GigabitEthernet2/1/3] mpls ldp enable
[P-GigabitEthernet2/1/3] quit
# Assign an IP address to Loopback 1, and enable PIM-SM on the interface.
[P] interface loopback 1
[P-LoopBack1] ip address 2.2.2.2 32
[P-LoopBack1] pim sm
[P-LoopBack1] quit
# Configure Loopback 1 as a C-BSR and C-RP on the public network.
[P] pim
[P-pim] c-bsr 2.2.2.2
[P-pim] c-rp 2.2.2.2
[P-pim] quit
# Configure OSPF.
[P] ospf 1
[P-ospf-1] area 0.0.0.0
[P-ospf-1-area-0.0.0.0] network 2.2.2.2 0.0.0.0
[P-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.255.255
5. Configure CE a1:
# Enable IP multicast routing.
199