HP MSR2003 Configuration Manual page 203

[PE1-GigabitEthernet2/1/1] pim sm
[PE1-GigabitEthernet2/1/1] mpls enable
[PE1-GigabitEthernet2/1/1] mpls ldp enable
[PE1-GigabitEthernet2/1/1] quit
# Bind GigabitEthernet 2/1/2 with VPN instance a, assign an IP address to GigabitEthernet
2/1/2, and enable IGMP on the interface.
[PE1] interface gigabitethernet 2/1/2
[PE1-GigabitEthernet2/1/2] ip binding vpn-instance a
[PE1-GigabitEthernet2/1/2] ip address 10.110.1.1 24
[PE1-GigabitEthernet2/1/2] igmp enable
[PE1-GigabitEthernet2/1/2] quit
# Bind GigabitEthernet 2/1/3 with VPN instance a, assign an IP address to GigabitEthernet
2/1/3, and enable PIM-SM on the interface.
[PE1] interface gigabitethernet 2/1/3
[PE1-GigabitEthernet2/1/3] ip binding vpn-instance a
[PE1-GigabitEthernet2/1/3] ip address 10.110.2.1 24
[PE1-GigabitEthernet2/1/3] pim sm
[PE1-GigabitEthernet2/1/3] quit
# Assign an IP address to Loopback 1, and enable PIM-SM on the interface.
[PE1] interface loopback 1
[PE1-LoopBack1] ip address 1.1.1.1 32
[PE1-LoopBack1] pim sm
[PE1-LoopBack1] quit
# Configure BGP.
[PE1] bgp 100
[PE1-bgp] group vpn-g internal
[PE1-bgp] peer vpn-g connect-interface loopback 1
[PE1-bgp] peer 1.1.1.2 group vpn-g
[PE1-bgp] peer 1.1.1.3 group vpn-g
[PE1–bgp] ip vpn-instance a
[PE1-bgp-a] address-family ipv4
[PE1-bgp-ipv4-a] import-route rip 2
[PE1-bgp-ipv4-a] import-route direct
[PE1-bgp-ipv4-a] quit
[PE1-bgp-a] quit
[PE1–bgp] address-family vpnv4
[PE1–bgp-vpnv4] peer vpn-g enable
[PE1–bgp-vpnv4] quit
[PE1–bgp] quit
# Configure OSPF.
[PE1] ospf 1
[PE1-ospf-1] area 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] network 1.1.1.1 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.255.255
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# Configure RIP.
193