Mld Ssm Mapping Configuration Example - HP MSR2003 Configuration Manual

Querier for MLD: FE80::200:5EFF:FE66:5100 (this router)
MLD groups reported in total: 1

MLD SSM mapping configuration example

Network requirements
As shown in
The IPv6 PIM-SM domain uses both the ASM model and SSM model for IPv6 multicast delivery.
•
GigabitEthernet 2/1/3 of Router D serves as the C-BSR and C-RP. The IPv6 SSM group range is
FF3E::/64.
MLDv2 runs on GigabitEthernet 2/1/1 of Router D. The receiver host runs MLDv1, and does not
•
support MLDv2. Therefore, the Receiver host cannot specify expected multicast sources in its
membership reports.
Source 1, Source 2, and Source 3 send IPv6 multicast packets to multicast groups in the IPv6 SSM
•
group range.
Configure the MLD SSM mapping feature on Router D so that the receiver host will receive IPv6 multicast
data from Source 1 and Source 3 only.
Figure 81 Network diagram
Source 2
Source 1
Table 19 Interface and IPv6 address assignment
Device
Source 1
Source 2
Router A
Router A
Router A
Router B
Router B
Router B
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to
shown.)
Figure 81:
Router B
GE2/1/1 GE2/1/3
GE2/1/2
IPv6 PIM-SM
GE2/1/2
GE2/1/1 GE2/1/3
Router A
Interface
—
—
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
Router C
GE2/1/3 GE2/1/1
GE2/1/2
GE2/1/2
GE2/1/3 GE2/1/1
Router D
IPv6
Device
address
1001::1/64 Source 3
2001::1/64 Receiver
1001::2/64 Router C
1002::1/64 Router C
1003::1/64 Router C
2001::2/64 Router D
1002::2/64 Router D
2002::1/64 Router D
269
Source 3
Receiver
Interface
—
—
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
Table 19. (Details not
IPv6
address
3001::1/64
4001::1/64
3001::2/64
3002::1/64
2002::2/64
4001::2/64
3002::2/64
1003::2/64