Ipv6 Pim-Sm Non-Scoped Zone Configuration Example - HP MSR2003 Configuration Manual

IPv6 PIM-SM non-scoped zone configuration example

Network requirements
As shown in
VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form stub
•
networks, and at least one receiver host exist in each stub network. The entire IPv6 PIM-SM domain
contains only one BSR.
• Host A and Host C are multicast receivers in the stub networks N1 and N2.
Specify GigabitEthernet 2/1/3 on Router E as a C-BSR and a C-RP. The C-RP is designated to the
•
IPv6 multicast group range FF0E::101/64. Specify GigabitEthernet 2/1/2 of Router D as the static
RP on all the routers to back up the dynamic RP.
MLDv1 runs between Router A and N1, and between Router B, Router C, and N2.
•
Figure 98 Network diagram
Table 22 Interface and IPv6 address assignment
Device
Router A
Router A
Router A
Router B
Router B
Router C
Figure 98:
Interface
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/1
IPv6 address Device
1001::1/64 Router D
1002::1/64 Router D
1003::1/64 Router D
2001::1/64 Router E
2002::1/64 Router E
2001::2/64 Router E
317
Interface
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
IPv6
address
4001::1/64
1002::2/64
4002::1/64
3001::2/64
2002::2/64
1003::2/64