Pim-Sm Non-Scoped Zone Configuration Example - HP MSR2003 Configuration Manual

PIM-SM non-scoped zone configuration example

Network requirements
As shown in
VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form stub
•
networks, and at least one receiver host exist in each stub network.
• The entire PIM-SM domain contains only one BSR.
Host A and Host C are multicast receivers in the stub networks N1 and N2.
•
Specify GigabitEthernet 2/1/3 on Router E as a C-BSR and a C-RP. The C-RP is designated to the
•
multicast group range 225.1.1.0/24. Specify GigabitEthernet 2/1/2 of Router D as the static RP on
all the routers to back up the dynamic RP.
IGMPv2 runs between Router A and N1, and between Router B, Router C, and N2.
•
Figure 44 Network diagram
Source
10.110.5.100/24
Table 8 Interface and IP address assignment
Device
Router A
Router A
Router A
Router B
Figure 44:
GE2/1/1 GE2/1/4
GE2/1/3
Router D
PIM-SM
Interface IP address
GigabitEthernet
10.110.1.1/24
2/1/1
GigabitEthernet
192.168.1.1/24
2/1/2
GigabitEthernet
192.168.9.1/24
2/1/3
GigabitEthernet
10.110.2.1/24
2/1/1
Router A
GE2/1/1
GE2/1/3
GE2/1/3
GE2/1/2
GE2/1/2
GE2/1/1
Router E
GE2/1/2
GE2/1/1
Router C
Device
Router D
Router D
Router D
Router E
119
Receiver
Host A
Host B
Receiver
GE2/1/1
Router B
Host C
Host D
Interface
GigabitEthernet
2/1/1
GigabitEthernet
2/1/2
GigabitEthernet
2/1/3
GigabitEthernet
2/1/1
IP address
10.110.5.1/24
192.168.1.2/24
192.168.4.2/24
192.168.3.2/24