Configuring BIDIR-PIM
This section describes how to configure BIDIR-PIM.
BIDIR-PIM configuration task list
Task at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
•
(Optional.)
NOTE:
You must configure a static RP, a C-RP, or both in a BIDIR-PIM domain.
In a network without C-RPs, skip the task of configuring a BSR.
Configuring a
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
Configuration prerequisites
Before you configure BIDIR-PIM, configure a unicast routing protocol so that all devices in the domain are
interoperable at the network layer.
Enabling BIDIR-PIM
Because BIDIR-PIM is implemented on the basis of PIM-SM, you must enable PIM-SM before you enable
BIDIR-PIM. When you deploy a BIDIR-PIM domain, HP recommends that you enable PIM-SM on all
non-border interfaces of the domain.
IMPORTANT:
All interfaces on a device must be enabled with the same PIM mode.
To enable BIDIR-PIM:
Step
1.
Enter system view.
2.
Enable
routing and enter MRIB
view.
3.
Return to system view.
4.
Enter interface view.
Enabling BIDIR-PIM
Configuring an
RP:
Configuring the maximum number of BIDIR-PIM RPs
BSR:
Configuring a C-BSR
Configuring a PIM domain border
Disabling the BSM semantic fragmentation function
Configuring common PIM features
Command
system-view
IP
multicast
multicast routing [ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
Remarks
N/A
By default, IP multicast routing is
disabled.
N/A
N/A
103