HP MSR2003 Configuration Manual page 336

Figure 100 Network diagram
Receiver 1
Host A
Source 1
Table 24 Interface and IPv6 address assignment
Device
Router A
Router A
Router B
Router B
Router B
Router C
Router C
Router C
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to
shown.)
Configure OSPFv3 on the routers in the IPv6 BIDIR-PIM domain to make sure the following
2.
conditions are met: (Details not shown.)
The routers are interoperable at the network layer.
The routers can dynamically update their routing information.
3. Enable IPv6 multicast routing, IPv6 PIM-SM, IPv6 BIDIR-PIM, and MLD:
# On Router A, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable
IPv6 BIDIR-PIM.
<RouterA> system-view
[RouterA] ipv6 multicast routing
Router B
GE2/1/1
GE2/1/2
GE2/1/2
GE2/1/1
Router A
Interface
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
Loopback 0
GE2/1/3 GE2/1/1
GE2/1/2
IPv6 BIDIR-PIM
GE2/1/3
IPv6
Device
address
1001::1/64 Router D
1002::1/64 Router D
2001::1/64 Router D
1002::2/64 Source 1
2002::1/64 Source 2
Receiver
2002::2/64
1
Receiver
3001::1/64
2
6001::1/12
8
326
Loop0
Router C
GE2/1/2
Router D
Interface
GigabitEthernet 2/1/1
GigabitEthernet 2/1/2
GigabitEthernet 2/1/3
—
—
—
—
Figure
Receiver 2
Host B
Source 2
IPv6 address
4001::1/64
5001::1/64
3001::2/64
1001::2/64
5001::2/64
2001::2/64
4001::2/64
100. (Details not