Device Overview And Setup; Connection For Configuration - Dimetix DLS-C 15 Technical Reference Manual

T R
ECHNICAL

3 Device overview and setup

We recommend that you carry out the configuration steps in an office before mounting the device, especially if you are not familiar with
the DLS-C(H)/FLS-C(H).
Configure the outputs first and second do the configuration of the operation mode. The following sections describe the configuration steps
and give an example.

3.1 Connection for configuration

To be able to configure the DLS-C(H)/FLS-C(H), it must be powered and connected to a PC. Figure 8 shows the necessary connections. On
the PC, any terminal program can be used to communicate with the module. A configuration utility is also available on the web page
www.dimetix.com.
Fig. 8 Connection for DLS-C(H)/FLS-C(H) configuration
Distance Laser Sensor
M
EFERENCE ANUAL
Tx
Rx
Gnd
9 pin
D-Sub
Default setting:
Baud: 19200
Bit: 7
Parity: even
Stop: 1
1
3
2
2
14,15
5
7,8
15 pin
D-Sub
9..30VDC
- +
24..30VDC for Heating option
DLS-C(H) DLS-C(H)
Rx
FLS-C(H)
Tx
GND
V+
Page 8/53