Specifications; Dls-C 15 / Dls-C - Dimetix DLS-C 15 Technical Reference Manual

T R
ECHNICAL

5.4 Specifications

Typical measuring accuracy for
DLS-C 15 / DLS-CH 15
DLS-C 30 / DLS-CH 30
FLS-C 10 / FLS-CH 10
FLS-C 30 / FLS-CH 30
Accuracy of the analog output
DLS-C(H)
FLS-C(H)
Typical repeatability for
DLS-C 15 / DLS-CH 15
DLS-C 30 / DLS-CH 30
FLS-C 10 / FLS-CH 10
FLS-C 30 / FLS-CH 30
Smallest unit displayed
Measuring range on natural surfaces
Measuring range on orange (reflective) target plate DLS-C(H)
Measuring reference
Typical diameter of laser spot at target at a distance of
(diffraction rings)
Time for a measurement
Single measurement:
Tracking:
Max target speed while moving target characteristic is active
Light source
Laser Life Time
ESD
EMC
Power supply
Dimensions
Temperature range during operation
DLS-C 15 / DLS-C 30 / FLS-C 10 / FLS-C 30
DLS-CH 15 / DLS-CH 30 / FLS-CH 10 / FLS-CH 30
Temperature range during storage
Degree of Protection
Weight
Standard interface
1) See 5.1 Measuring accuracy on page 21.
2) In case of permanent continuous measurement (tracking mode) the max. temperature is reduced to 45°C
3) Accuracy and measurement speed depend on configuration (See 9.3.2 Measuring characteristic configuration (sNuc) on page 34)
4) By measuring on the orange reflecting target plate the accuracy may be reduced to ± 1.5 mm @ 2
5) The spot-size can vary depending on production lot
Distance Laser Sensor
M
EFERENCE ANUAL
1)
1)
1,3,4)
1,3)
1)
1)
1)
1)
FLS-C(H)
5)
DLS-C(H) / FLS-C(H) 3)
DLS-C(H) 3)
FLS-C(H) 3)
2)
± 1.5 mm @ 2
σ
± 3.0 mm @ 2 σ
± 1.0 mm @ 2 σ
± 3.0 mm @ 2 σ
(9.3.6 Set/Get analog output distance range (sNv) on page 36)
0.2% programmed span (12 Bit)
0.1% programmed span (12 Bit)
± 0.4 mm @ 2
σ
± 0.5 mm @ 2
σ
± 0.3 mm @ 2 σ
± 0.5 mm @ 2 σ
0.1 mm
0.05 m to approx. 65 m (80m on natural surface characteristic
Approx. 25 m to 150 m
Approx. 0.5 m to 500 m
from front edge
(See 7 Physical dimensions)
4mm @ 5m; 8mm @ 10m; 15mm @ 30m
Typical: 0.3 s to 4 s
Typical: 0.15 s to 4 s
Typical: 4 ms to 4 s
Typical: 10m/s up to 150m
7m/s up to 500m/s
Laser diode 620-690 nm (red)
IEC 60825-1:2007; Class 2
FDA 21CFR 1040.10 and 1040.11
typical 50'000h @ 20°C
(See 4.1.4 Laser Life time consideration on page 17)
IEC 61000-4-2
EN 61000-6-4
EN 61000-6-2
9 ... 30V DC 0.6A for DLS-C / FLS-C
24 ... 30V DC 2.5A for DLS-CH /FLS-CH(Heating option)
150 x 80 x 55 mm
-10 °C to +50 °C
-40 °C to +50 °C
-40 °C to +70 °C
IP65; IEC60529 (protected against ingress of dust and water)
DLS-C, FLS-C: 690 g
DLS-CH, FLS-CH: 720 g
1 serial asynchronous interface RS-232
1 serial asynchronous interface RS-422
1 SSI (only FLS-C(H))
1 programmable analog output 0/4 .. 20mA
2 programmable digital outputs
1 programmable digital input
1 digital output for error status
3)
)
Beam divergence:0.16 x 0.6 mrad
Pulse duration: 0.45x10 -9 s
Maximum radiant power: 0.95 mW
s
Page 23/53