User Output Protocol (Snuo) - Dimetix DLS-C 15 Technical Reference Manual

T R
ECHNICAL

9.5.4 User output protocol (sNuo)

This command modifies the output for the user configured commands. The output can be configured to fit the requirement of an external
display.
A parameter for the output mode between 100 and 189 defines the format for an external display. The last digit of the parameter defines
the field length for the output number. The output of a distance measurement will be right aligned. The decimal point will be inserted at
the position (counted from right) defined by middle digit (See 3.5.2 Output format on page 15).
Command
Return successful
Return error
Parameters
Configuration parameters need to be saved (See 9.3.13 Save configuration parameters (sNs) on page 40)
Distance Laser Sensor
M
EFERENCE ANUAL
Set command
sNuo+xxxxxxxx<trm>
gNuo?<trm>
gN@Ezzz<trm>
N Device ID
xxxxxxxx Output Mode
0: display distance
1: display additional information
1ab: output formatted for external display
a: Number of digits after decimal point
b: Field with (sign included) must be greater than 0
Conditions: a≤b, if a=b, no decimal point is output.
zzz Error code
Get command
sNuo
gNuo+xxxxxxxx<trm>
gN@Ezzz<trm>
Page 46/53