Operation Commands; Distance Measurement (Sng); Single Sensor Tracking (Snh); Single Sensor Tracking With Timer(Snh) - Dimetix DLS-C 15 Technical Reference Manual

T R
ECHNICAL

9.2 Operation commands

9.2.1 Distance measurement (sNg)

Triggers simple measurement of distance. Each new command cancels an active measurement.
Command
Return successful
Return error
Parameters

9.2.2 Single sensor tracking (sNh)

Triggers continuous measurements of the distance. The measurements are made as fast as possible (Measurement speed depends on target
conditions). This command is not to be used with more than one DLS-C(H)/FLS-C(H) on a RS-232/RS-422 line. The measurements are
continued until the STOP/CLEAR command is issued. The status LEDs and the digital outputs are updated corresponding to the new
measured distance.
Never use this command if more than one module is connected to the RS-232/RS-422 line
Command
Return successful
Return error
Parameters

9.2.3 Single sensor tracking with timer(sNh)

This command does the same as the
Never use this command if more than one device is connected to the RS-422 line
Command
Return successful
Return error
Parameters
Distance Laser Sensor
M
EFERENCE ANUAL
Command
sNg<trm>
gNg+xxxxxxxx<trm>
gN@Ezzz<trm>
N Device ID
xxxxxxxx Distance in 1/10 mm
zzz Error code
Command
sNh<trm>
gNh+xxxxxxxx<trm>
gN@Ezzz<trm>
N
Device ID
xxxxxxxx
Distance in 0.1mm
zzz Error code
sNf
command, but the unit sends the results directly to the output.
Command
sNh+xxx<trm>
gNh+yyyyyyyy<trm>
gN@Ezzz<trm>
N Device ID
xxx Sampling time in 10ms (if 0 -> use max. possible sample rate)
yyyyyyyy Distance in 0.1mm
zzz Error code
Page 30/53