Siemens SIPROCESS GA700 Quick Start Manual page 43

4. Call the measured-value display during the warming-up phase
5. Call the main menu:
6. Identify device: [3.09] Maintenance & diagnostics > Identification (Page 45).
7. Define PINs for the user levels:
8. Define measuring ranges:
9. Set digital inputs: [2.09.3] Digital inputs (Page 55)
10. Set digital outputs [2.09.5] Digital outputs (Page 61).
11. Check setting of gas path and change, if necessary: [2.12] Settings > Gas path/process
12. Calibrate the device: [2.08] Settings > Calibrations (Page 70).
Quick Start
Compact Operating Instructions, 01/2013, A5E31805656-01
– Close the warming-up window by pressing <ENTER>.
The display shows the measured-value display in read mode.
For the duration of the warming-up phase, the device is in "Function check" mode.
The following symbol is displayed in the status bar:
– Switch the measured-value display to selection mode. To do so, press <ENTER>.
– Press <Enter> again to open the main menu.
The PIN required for initial commissioning is: 0000. (Standard: 1111, Expert: 2222)
Assigning/changing PIN (Page 49).
[2.03] Settings > Measuring ranges (Page 51) > Setting the measuring ranges (Page 53)
tag label (Page 69).
– Familiarize yourself with the basics of calibration. Device-internal characteristics are
changed during calibration: Basics (Page 70).
– Prepare for the calibration. Set the setpoints, calibration tolerances, and the sample
gas purging time: [2.08.1] Setpoints, tolerances, flow time (Page 74).
– Assign parameters for a calibration process: [2.08.3] Carry out calibrations (Page 79).
7.2 Commissioning the SIPROCESS GA700
Commissioning
43