Siemens SIPROCESS GA700 Quick Start Manual page 19

● Ensure that a mains disconnection device is located in the direct vicinity of the device (for
● Ensure that the supply voltage present matches that which is specified on the nameplate
1. Connect the wires of the connecting cable to the appliance plug
2. Connect the appliance plug
Quick Start
Compact Operating Instructions, 01/2013, A5E31805656-01
load rating, see nameplate).
of the device.
account.
Note
Fastening screws
Tighten the screws in the appliance plug with a torque of
• 0.5 Nm to the connecting terminals,
• 0.3 Nm to the cable terminals (strain relief) and the connector housing.
These values apply to the optionally ordered power connector.
3 2 1
①
Power supply unit
③
Appliance plug
Figure 4-1 Electrical connection
③
to the power supply unit
②
Ground connection
Connecting
4.1 Electrical connections
③
. Take the polarity into
①
.
19