Electrical Connections/Terminal Assignment - Siemens SIPROCESS GA700 Quick Start Manual

Continuous gas analysis

Hide thumbs Also See for SIPROCESS GA700:

Table of Contents

The mains supply line must comply with the valid regulations and conditions for the place of

installation and be provided with a protective conductor at the potential of the housing. The

cross-section of each wire has to be ≥ 1 mm

connected in the connector at the position marked.

● Ensure that a mains disconnection device is located in the direct vicinity of the device (for

● Ensure that the supply voltage present matches that which is specified on the nameplate

4.1.3.2

Electrical connections/terminal assignment

Figure 4-6

Pin assignment of standard terminal block, terminal rows A and B

Quick Start

Compact Operating Instructions, 01/2013, A5E31805656-01

load rating, see nameplate).

of the device.

. The phased terminal conductors must be

Connecting

4.1 Electrical connections

Table of Contents