Vecow EVS-1000 User Manual page 48

2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin pluggable
terminal block located in the back panel. It is below the general wiring configuration.
Pin No. Definition
1 Ignition (IGN)
2 External Power S/W +
3 External Power S/W +
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
Note :
1. DC power source and IGN share the same ground.
2. EVS-1000/1100 supports 10V to 36V wide range DC power input in ATX/AT
mode. In Ignition mode, the input voltage is fixed to 12V/24V for car battery
scenario.
3. For proper ignition control, the power button setting should be "Power Down"
mode.
V+
IGN
GETTING TO KNOW YOUR EVS-1000/1100
In Windows, for
example, you need
to set "When I press
the power button" to
"Shut down."
41