Ethernet Port - Vecow EVS-1000 User Manual

2.2.9 Ethernet Port

RST
There are dual 8-pin RJ-45 jacks supporting 10/100/1000 Mbps Ethernet
connections in the front side. LAN 1 is powered by Intel I219 Ethernet Phy and
LAN 2 is powered by Intel I210 Ethernet engine. When both LAN 1 and LAN 2
work at normal status, iAMT 11.0 function is enabled.
Using suitable RJ-45 cable, you can connect the system to a computer or to
any other devices with Ethernet connection; for example, a hub or a switch.
Moreover, both LAN 1 and LAN 2 support Wake on LAN and Pre-boot functions.
The pin-outs of LAN 1 and LAN 2 are listed as follows :
Pin No.
1
2
3
4
5
6
7
8
Each LAN port is supported by standard RJ-45 connector with LED indicators to
present Active/Link/Speed status of the connection.
The LED indicator on the right bottom corner lightens in solid green when the
cable is properly connected to a 100 Mbps Ethernet network; The LED indicator
on the right bottom corner lightens in solid orange when the cable is properly
connected to a 1000Mbps Ethernet network; The left LED will keep twinkling/off
when Ethernet data packets are being transmitted/received.
Right
Bottom LED
©Vecow EVS-1000/1100 User Manual
SIM 1 SIM 3
1 2 3
SIM 2
WLAN
CFast
10/100 Mbps
E_TX+
E_TX-
E_RX+
-
-
E_RX-
-
-
10 Mbps 100 Mbps
Off Solid Green
Flash Yellow Flash Yellow
DVI-D DP
VGA
1000 Mbps
1000 Mbps
Solid Orange
Flash Yellow
GETTING TO KNOW YOUR EVS-1000/1100
LAN 1
LAN 2
MDI0_P
MDI0_N
MDI1_P
MDI2_P
MDI2_N
MDI1_N
MDI3_P
MDI3_N
1 8
14