Configuring The Downstream Frequency; Administering The Cable Modem - Ruckus Wireless ZoneFlex 7761-CM Installation Manual

Configuring the Downstream Frequency

The Connection Status page allows you to set the downstream frequency for the cable
modem. Configuring the downstream frequency enables the device to quickly obtain a
direct frequency lock with the CMTS upon bootup and helps to save several minutes of
scanning for an available downstream frequency from the CMTS.
1. If not already done, log into to the Status page as described in
Web Interface using Dynamic IP"
using the CMAP Ethernet Port"
2. Click Connection on the menu on the left sidebar. The CM web interface displays the
Connection Status page.
3. Scroll down to the Downstream Frequency Select (in KHz) parameter. See
4. Enter the downstream frequency (in kiloHertz) that you want the cable modem to use
to connect to the CMTS when it boots up.
5. Click TUNE to have the cable modem save your changes.

Administering the Cable Modem

The parameters on the Security Status page allow you to change the CM login and
password, enable or disable firewall protection, and/or restore the factory defaults.
1. If not already done, log into to the Status page as described in
Web Interface using Dynamic IP"
using the CMAP Ethernet Port"
2. Click Security on the menu on the left sidebar. The CM web interface displays the
Security Status page.
Configuring the Downstream Frequency
on page 40 or "Logging Into the CM Web Interface
on page 40.
on page 40 or "Logging Into the CM Web Interface
on page 40.
45
Cable Modem Operation
"Logging Into the CM
Figure 28.
"Logging Into the CM