Connect The Switch To A Power Source - Aruba 2930F 24G 4SFP Plus Installation And Getting Started Manual

To remove the transceivers that have the wire bail, lower the bail until it is approximately horizontal. Using the bail,
pull the transceiver from the slot.

Connect the switch to a power source

Procedure
1. Depending on your switch model, do one of the following:
a. For the Aruba 2930F 24-port and 48-port switches, plug the included power cord into the switch's power
connector and into a nearby AC power source.
Figure 18: Connecting the power cord on 2930F 24-port and 48-port switches
b. For the Aruba 2930F 8G PoE+ 2SFP+ Switch, plug the AC/DC adapter's power cord into the switch, and
then plug the AC/DC power adapter into a nearby AC power source.
36 Aruba 2930F Switch Series Installation and Getting Started
Guide