Led Behavior - Aruba 2930F 24G 4SFP Plus Installation And Getting Started Manual

2. Check the LEDs on the switch as described below.
Figure 7: Example of LEDs on the 2930F switches
Table 9: Example of LEDs on the 2930F switches labels and descriptions
Label
1
2
3
4
When the switch is powered on, it performs its diagnostic self test and initialization. This boot process,
depending on switch model and configuration, takes approximately 1-2 minutes to complete.

LED behavior:

During the switch boot:
• The Global Status, UID, other status, and mode LEDs, will initially turn green, and bi-color LEDs will change to
orange, then back to green.
• The Global Status LED will start blinking green, indicating that the switch is going through its self-test and will
continue to blink green until the switch is fully booted.
• The port LEDs will initially turn green, then turn orange, turn back to green, and then may blink on and off
during phases of the boot.
When the switch boots successfully, the following LEDs display:
• Global Status will be solid green.
• UID LED is off.
26
The 2930F 24-port and 48-port switches do not have a power switch. They are powered on when
the power cord is connected to the switch and to a power source. For safety, the power outlet
should be located near the switch installation.
The switch automatically adjusts to any voltage between 100-127 or 200-240 volts and either 50
or 60 Hz. There are no voltage range settings required.
The Aruba 2930F 8G PoE+ 2SFP+ Switch also does not have a power switch. It is powered on
when the external AC/DC power adapter is connected to the switch and the adapter power cord
to a power source. The external AC/DC power adapter automatically adjusts to any voltage
between 100-240 volts and either 50 or 60 Hz. Be sure to release the latch on the DC plug before
removing the adapter power cord. (See Figure 19: Aruba 2930F 8G PoE+ 2SFP+ Switch power
plug latch on page 37.)
Description
SFP/SFP+ port LEDs
RJ-45 port LEDs
Global Status and UID LEDs
Mode LEDs
Aruba 2930F Switch Series Installation and Getting Started
Guide