Where To Go From Here - Aruba 2930F 24G 4SFP Plus Installation And Getting Started Manual

Parameter
Logon Default
Time Zone
Community Name
Spanning Tree Enabled
Default Gateway
Time Sync Method
TimeP Mode
IP Config (DHCP/ Bootp)
IP Address
Subnet Mask

Where to go from here

The above procedure configures your switch with a Manager password, IP address, and subnet mask. As a
result, with the proper network connections, you can now manage the switch from a PC equipped with Telnet,
and/or a web browser interface.
46
Default
CLI
0 (none)
public
No
blank
None
Disabled
DHCP/Bootp
xxx.xxx.xxx.xxx
The IP address and subnet mask assigned for the switch must be compatible with the IP
addressing used in your network. For more information on IP addressing, see the Management
and Configuration Guide .
xxx.xxx.xxx.xxx
Aruba 2930F Switch Series Installation and Getting Started
The default setting selects the
command line interface for console
access. The alternative is the
menu interface.
Optional; 1440 to -1440. The
number of minutes your location is
to the West (-) or East (+) of GMT.
Default setting recommended.
Default setting recommended
unless STP is already running on
your network or the switch will be
used in complex network
topologies.
Optional; Enter the IP address of
the next-hop gateway node if
network traffic needs to be able to
reach off-subnet destinations.
Optional; The protocol the switch
uses to acquire a time signal. The
options are NTP, SNTP, TimeP,
and TimeP/SNTP.
Optional; The method the switch
uses to acquire the TimeP server
address.
Set to Manual unless a DHCP/
Bootp server is used on your
network to configure IP
addressing.
Recommended; If you set IP
Config to Manual, then enter an IP
address compatible with your
network.
Recommended; If you entered an
IP address, then enter a subnet
mask compatible with your
network.
Guide