Console Cable Pinouts; Connect The Network Cables; Using The Rj-45 Connectors - Aruba 2930F 24G 4SFP Plus Installation And Getting Started Manual

Console cable pinouts

The console cable has an RJ-45 plug on one end and a DB-9 female connector on the other end. The figure
below displays the mapping of the RJ-45 to DB-9 pins.
Figure 22: RJ-45 to DB-9 pinouts
Table 10: Mapping of RJ-45 to DB-9
RJ-45 (Signal reference from chassis)
Reserved
Reserved
TXD
Reserved
GND
RXD
Reserved
Reserved

Connect the network cables

Connect the network cables, described under Cabling and technology information on page 64, from the
network devices or your patch panels to the fixed RJ-45 ports on the switch or to any SFPs you have installed in
the switch.

Using the RJ-45 connectors

To connect, push the RJ-45 plug into the RJ-45 jack until the tab on the plug clicks into place. When power is on
for the switch and for the connected device, the port LED should light to confirm a powered-on device (for
example, an end node) is at the other end of the cable. If the port LED does not come on when the network cable
40
1 8
2 6
3 2
4 1
5 5
6 3
7 4
8 7
9
Aruba 2930F Switch Series Installation and Getting Started
DB-9 (Signal reference from PC)
CTS
DSR
RXD
DCD
GND
TXD
DTR
RTS
RI
Guide