Led Mode Select Button And Indicator Leds; Reset And Clear Buttons - Aruba 2930F 24G 4SFP Plus Installation And Getting Started Manual

Switch LEDs
Speed mode selected
PoE mode selected***
* The slow blink behavior is an on/off cycle once every 1.6 seconds, approximately.
** The fast blink behavior is an on/off cycle once every 0.8 seconds, approximately.
*** Applies only to switches that support PoE/PoE+.

LED mode select button and indicator LEDs

The state of the Mode LEDs is controlled by the LED Mode select button. The current view mode is indicated by
the Mode LEDs next to the button. Press the button to step from one view mode to the next. See Table 6: Front
of switch status and mode LED behavior on page 11.

Reset and Clear buttons

The Reset and Clear buttons are recessed from the front panel (to protect them from being pushed accidentally)
and are accessible through small holes on the top of the front panel. Use pointed objects, such as unbent paper
clips, to push them.
The Reset and Clear buttons are used singly or in combination, as follows:
14
Function
Port LEDs are displaying
the connection speed at
which each port is
operating.
Port LEDs are displaying
PoE information.
Aruba 2930F Switch Series Installation and Getting Started
State/Mode
Off
On green
Slow flash green*
Off
On green
On orange
Fast flash orange**
Slow flash orange*
Off
Meaning
The port is disabled, not
connected, or not
receiving a link.
The port is operating at 10
Gbps.
The port is operating at 1
Gbps.
The port is not Linked, or
is operating at 10 or 100
Mbps.
The port is providing PoE
power.
PoE is disabled on the
port.
The port is denied power
or is detecting an external
PD fault.
The port has an internal
hardware failure. Flashes
simultaneously with the
Global Status LED
flashing orange.
The port is not providing
PoE power.
Guide