Mounting The Aruba 2930F 8G Poe+ 2Sfp+ Switch (Jl258A); Mount The Switch - Aruba 2930F 24G 4SFP Plus Installation And Getting Started Manual

Horizontal surface mount option
Place the switch on a table or other horizontal surface. The switch comes with rubber feet in the accessory kit that
can be used to help keep the switch from sliding on the surface.
Attach the rubber feet to the four corners on the bottom of the switch within the embossed angled lines. Use a
sturdy surface in an uncluttered area. You may want to secure the networking cables and switch power cord to the
table leg or other part of the surface structure to help prevent tripping over the cords.
Figure 10: Mounting the 2930F 24- and 48-port switches on a horizontal surface

Mounting the Aruba 2930F 8G PoE+ 2SFP+ Switch (JL258A)

The supported mounting options for the Aruba 2930F 8G PoE+ 2SFP+ Switch include:
• Rack mount
• Horizontal surface mount
• Under-table mount
• Wall mount
To mount the Aruba 2930F 8G PoE+ 2SFP+ Switch with the optional JL312A Power Adapter Shelf,
use the printed instructions provided with the shelf, then continue with the next section in this guide.
o mount the Aruba 2930F 8G PoE+ 2SFP+ Switch with the optional JL311A Cable Guard, see the
printed instructions included with the cable guard unit to attach the cable guard and mount the
switch.
Aruba 2930F 8G PoE+ 2SFP+ Switch warm product and other mounting information
• If you are mounting the Aruba 2930F 8G PoE+ 2SFP+ Switch in a rack with other products, the preferred
position for the switch is at the base of the rack (for optimal cooling), or below as many of the other products
as can be accommodated.
• When mounted in a rack, ensure that a 1U (44.45 mm / 1.75-inch) vertical space is left between the Aruba
2930F 8G PoE+ 2SFP+ Switch and the device above it.
Chapter 2 Installing the switch 29