Safety Listings; Fcc Compliance; Class B Digital Device; Industry Canada Compliance - 3M SCOTT SEMS II PRO Operation And Maintenance Instructions

SAFETY LISTINGS

FCC COMPLIANCE

FCC Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
FCC Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This portable transmitter with its antenna complies with FCC's RF exposure limits
for general population / uncontrolled exposure.

CLASS B DIGITAL DEVICE

Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

INDUSTRY CANADA COMPLIANCE

Industry Canada Statement
The term "IC" before the certification / registration number only signifies that the
Industry Canada technical specifications were met.
The installer of this radio equipment must ensure that the antenna is located or
pointed such that it does not emit RF field in excess of Health Canada limits for the
general population. Consult Safety Code 6, obtainable from Health Canada's web
site: https://www.canada.ca/en/health-canada.html
This device complies with Industry Canada's license-exempt RSSs. Operation is
subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that
may cause undesired operation of the device.
La Déclaration de Canada d'industrie
L' « IC » de terme avant que la certification/le nombre d'enregistrement signifie
seulement que le Canada d'Industrie spécifications techniques ont été rencontrées.
Le programme d'installation de cet équipement de radio doit garantir que l'antenne
est localisée ou tel est indiqué qu'il n'émet pas le champ de RF dépassant les
limites de Canada de Santé pour la population générale. Consulter le Code de
Sécurité 6, procurable du site Web de Canada de Santé : https://www.canada.ca/
en/health-canada.html
Cet appareil est conforme aux normes Industry Canada exemptes de licence RSS
standard(s). L'opération est assujetti au suivre deux conditions:
1) cet appareil ne peut pas causer l'intervention, et
2) cet appareil doit accepter de l'intervention, y compris l'intervention
qui peut causer l'opération non désirée de l'appareil.
RADIO FREQUENCY INTERFERENCE (RFI)
MAY CAUSE A MALFUNCTION OF THE PASS
DEVICE. USERS OF RESPIRATORS EQUIPPED
WITH A PASS DEVICE MUST BE AWARE OF THE
PROPER OPERATION OF THE PASS DEVICE.
FAILURE TO RECOGNIZE A MALFUNCTION
OF THE PASS DEVICE AND TAKE PROPER
CORRECTIVE ACTION MAY RESULT IN SERIOUS
INJURY OR DEATH.
DO NOT USE A FIBERGLASS WRAPPED ONE
HOUR CYLINDER ON A MODEL 4.5 AIR-PAK
SCBA EQUIPPED WITH A PASS DEVICE AS THE
WEIGHT WILL EXCEED THE 35-LB APPROVAL
LIMIT FOR SCBA'S ESTABLISHED BY NIOSH.
Page 23 of 28
WARNING
CAUTION
P/N 595369-01 Rev B 07/19