Tzidc-210 / Tzidc-220 - ABB TZIDC-200 Operating Instructions Manual

Commissioning
7.2

TZIDC-210 / TZIDC-220

bieten
1. Feed in pneumatic supply power
2. Connect the bus to the bus terminals with any polarity (or supply power 9 ... 32 V DC)
3. Check mount:
•
•
•
•
4. Go back to the bus level:
•
5. Run Autoadjust
•
For linear actuators
•
•
•
For rotary actuators
•
•
•
32
°
C
%
is displayed
mA
Press and hold down
release and
Press and hold down
Additionally, press or
range) is displayed. Release
Press or to move the actuator into the mechanical end position; check the end
positions; rotation angle is displayed in degrees (for high-speed mode, press
simultaneously)
Recommended range:
- between -28 ... 28° for linear actuators
- between -57 ... 57° for rotary actuators
Minimum angle: 25°
Press and hold down
release and
°
C
%
is displayed.
mA
Check that the unit is on the bus level ("REMOTE")
1)
:
Press and hold down
Press again and hold down until the countdown ends
Release ; this starts Autoadjust
1)
:
Press and hold down
Press again and hold down until the countdown ends
Release ; this starts Autoadjust
TZIDC-200, TZIDC-210, TZIDC-220
and ; once the countdown has gone from 3 to 0,
; the unit switches to the operating level, mode 1.x
and .
until operating mode 1.3 (manual adjustment within the sensor
and ; once the countdown has gone from 3 to 0,
until is displayed. Release the control button
until is displayed. Release the control button
and
42/18-85-EN