ABB TZIDC-200 Operating Instructions Manual page 19

Fig. 11: Linkage for positioner
1 larger
The scale on the lever indicates the link points for the various stroke ranges of the valve.
Move the bolt with the follower pin in the oblong hole of the lever to adjust the stroke range of
the valve to the working range for the position sensor.
Moving the link point inwards increases the rotation angle of the sensor. Moving the link point
outwards reduces the rotation angle of the sensor.
Adjust the actuator stroke so that you can make use of as large an angle of rotation as possible
(symmetrical around the center position) on the position sensor.
Recommended range for linear actuators:
Minimum angle:
IMPORTANT (NOTE)
After mounting, check whether the positioner is operating within the sensor range.
42/18-85-EN TZIDC-200, TZIDC-210, TZIDC-220
2 smaller
between -28 ... 28°
25°
Mounting
19