Disposal; Information On Weee Directive 2002/96/Ec (Waste Electrical And Electronic Equipment); Rohs Directive 2002/95/Ec; Ex Relevant Safety Instructions - ABB TZIDC-200 Operating Instructions Manual

Ex relevant safety instructions

1.13 Disposal

This product is manufactured from materials that can be reused by specialist recycling
companies.

1.13.1 Information on WEEE Directive 2002/96/EC (Waste Electrical and Electronic Equipment)

This product is not subject to WEEE Directive 2002/96/EC or relevant national laws
(e.g., ElektroG in Germany).
The product must be disposed of at a specialist recycling facility. Do not use municipal garbage
collection points. According to the WEEE Directive 2002/96/EC, only products used in private
applications may be disposed of at municipal garbage facilities. Proper disposal prevents
negative effects on people and the environment, and supports the reuse of valuable raw
materials.
If it is not possible to dispose of old equipment properly, ABB Service can accept and dispose of
returns for a fee.

1.13.2 RoHS Directive 2002/95/EC

With the Electrical and Electronic Equipment Act (ElektroG) in Germany, the European
Directives 2002/96/EC (WEEE) and 2002/95/EC (RoHS) are translated into national law.
ElektroG defines the products that are subject to regulated collection and disposal or reuse in
the event of disposal or at the end of their service life. ElektroG also prohibits the marketing of
electrical and electronic equipment that contains certain amounts of lead, cadmium, mercury,
hexavalent chromium, polybrominated biphenyls (PBB), and polybrominated diphenyl ethers
(PBDE) (also known as hazardous substances with restricted uses).
The products provided by ABB Automation Products GmbH do not fall within the current scope
of the directive on waste from electrical and electronic equipment according to ElektroG. If the
necessary components are available on the market at the right time, in the future these
substances will no longer be used in new product development.
2 Ex relevant safety instructions
Depending on the type of explosion protection, an Ex label is attached to the left-hand side of
the positioner, next to the main name plate. It indicates the level of explosion protection and the
device's relevant Ex certificate.
Requirements/Preconditions for safe operation of positioners:
IMPORTANT (NOTE)
Observe the units' relevant technical data and special conditions in accordance with the
applicable certificate.
• Manipulation of the devices by users is not permitted. Modifications to the devices may only
be performed by the manufacturer or an explosion protection specialist.
10 TZIDC-200, TZIDC-210, TZIDC-220 42/18-85-EN