Mounting; Operating Conditions At Installation Site; Mechanical Mount; General Information - ABB TZIDC-200 Operating Instructions Manual

4

Mounting

CAUTION - Risk of injury!
Incorrect parameter values can cause the valve to move unexpectedly. This can lead to
process failures and result in injuries.
Before recommissioning a TZIDC-200, TZIDC-210, TZIDC-220 positioner that was used at
another location, the device must always be reset to factory settings. Never start Autoadjust
before restoring factory settings.
4.1

Operating conditions at installation site

IMPORTANT (NOTE)
Before installation, check whether the TZIDC-200, TZIDC-210, TZIDC-220 positioner meets
the control and safety requirements for the installation location (actuator or valve).
See chapter Specifications page 39.
4.2

Mechanical mount

cke
4.2.1

General information

Fig. 3: Operating range
The arrow (1) on the positioner feedback shaft (and hence the lever) must move through the
area marked by the arrows (2).
42/18-85-EN TZIDC-200, TZIDC-210, TZIDC-220
Mounting
13