Setting The Bus Address - ABB TZIDC-200 Operating Instructions Manual

Commissioning
7.2.1

Setting the bus address

1. Switch to the configuration level:
•
•
•
•
2. Switch to parameter group 1.5:
•
•
•
3. Setting the bus address
•
•
•
•
The new bus address is saved.
4. Switch to parameter 1.6 (Return to operating level) and save the new setting:
•
•
•
•
•
The new parameter setting is saved and the positioner automatically returns to the working
level, continuing to run on the operating level that was active prior to the configuration level
being called up.
34
Press and hold down
Press and release
Wait for the countdown to go from 3 to 0.
Release and ;
is displayed.
co nf
Press and hold down
Press or ;
%
is displayed.
conf
Release ;
is displayed.
conf
Press or to set the correct value.
Press and hold down
Wait for the countdown to go from 3 to 0.
Release .
Press and hold down
Press and release twice;
%
is displayed.
co nf
Release .
Press and release to select
Press and hold down
TZIDC-200, TZIDC-210, TZIDC-220
and simultaneously.
.
and simultaneously.
.
.
.
for the countdown to go from 3 to 0.
42/18-85-EN