Tzidc-210 / Tzidc-220 - ABB TZIDC-200 Commissioning Instructions

6.2

TZIDC-210 / TZIDC-220

bieten
1. Feed in pneumatic auxiliary power
2. Connect the bus to the bus terminals with any polarity (or auxiliary power 9 ... 32 V DC),
3. Check mount:
•
•
•
•
4. Go back to the bus level:
•
5. Run Autoadjust.
•
For linear actuators
•
•
•
For rotary actuators
•
•
•
CI/TZIDC-200/210/220-EN
° C
%
is displayed
mA
Press and hold down
release and
Press and hold down
Additionally, press or
range) is displayed. Release
Press or to move the actuator into the mechanical end position. Check the end
positions. The rotation angle is displayed in degrees. For high-speed mode, press
simultaneously.
Recommended range:
- between -28 ... 28° for linear actuators
- between -57 ... 57° for rotary actuators
Minimum angle: 25°
Press and hold down
release and
° C
%
is displayed.
mA
Check that the unit is on the bus level ("REMOTE")
1)
:
Press and hold down
Press again and hold down until the countdown ends
Release . This starts Autoadjust
1)
:
Press and hold down
Press again and hold down until the countdown ends
Release . This starts Autoadjust
TZIDC-200, TZIDC-210, TZIDC-220
and . On completion of the countdown from 3 to 0,
. The unit switches to the operating level, mode 1.x
and
until operating mode 1.3 (manual adjustment within the sensor
and . On completion of the countdown from 3 to 0,
,
until is displayed. Release the control button
until is displayed. Release the control button
Commissioning
and
EN - 25