Mechanical Digital Feedback With Proximity Switches; Mechanical Feedback With Micro Switches For 24 V - ABB TZIDC-200 Operating Instructions Manual

Electrical connections
ch
5.3.2

Mechanical digital feedback with proximity switches

1. Loosen the screws for the housing cover and remove it.
CAUTION - Risk of injury!
The device includes slot sensors with sharp edges. Use a screwdriver to adjust slot sensors.
2. Set the upper and lower switching points for digital feedback as follows:
• Select operating mode 1.2 (see page 35) and move the valve by hand into the lower
switching position.
• Use a screwdriver to adjust the slot sensor for proximity switch 1 (lower contact) until it
closes the contact (i. e. until shortly before entering the proximity switch) on the feedback
shaft; the slot sensor enters proximity switch 1 when rotating to the right of the feedback
shaft (viewed from the front).
• Move the valve by hand into the upper switching position.
• Use a screwdriver to adjust the slot sensor for proximity switch 2 (upper contact) until it
closes the contact (i. e. until shortly before entering the proximity switch) on the feedback
shaft; the slot sensor enters proximity switch 2 when rotating to the left of the feedback shaft
(viewed from the front).
3. Attach the housing cover and screw onto housing; hand-tighten screws.
5.3.3

Mechanical feedback with micro switches for 24 V

1. Set max. contact (1, lower washer); fasten the upper washer with the special adjustment
retainers and rotate lower disk manually to adjust.
2. Set min. contact (2, upper washer); fasten the lower washer with the special adjustment
retainers and rotate upper disk manually to adjust.
3. Connect the micro switch.
4. Attach the housing cover and screw onto housing; hand-tighten screws.
26 TZIDC-200, TZIDC-210, TZIDC-220 42/18-85-EN