White Shading Offset Adj. (+18 Db); White Shading Offset Adj. (+18 / +12 Db); White Shading Adj. (Standard) - Panasonic AJ-SDX900P Service Manual

Video Monitor
Waveform (R, G, B) (H. Rate)
2-27. White Shading Offset Adj.
(+18 dB)
BOARD PREPROCESS Board
TP VIDEO OUT (R, G, B)
ADJ. EVR
F No. CLOSE
CHART -
MODE CAM
M. EQ. Waveform Monitor
SPEC. FLAT
1. Set the Lens close.
2. Confirm that the WHITE BAL is "PRST".
3. Click the "26. White Shading Offset Adjustment
+18dB" of the camera adjustment software.
4. Adjust the slider on the PC so that the waveform
becomes FLAT as shown in 2-26.
5. Click ">>".
6. Adjust the slider on the PC so that the waveform
becomes FLAT as shown in 2-26.
7. Click ">>".
8. Adjust the slider on the PC so that the waveform
becomes FLAT as shown in 2-26.
9. Click ">>".
10. Confirm that the picture on the monitor is FLAT (no
color shading). If the color shading is appeared, adjust
again.
2-28. White Shading Offset Adj.
(+18 / +12 dB)
BOARD PREPROCESS Board
TP VIDEO OUT (R, G, B)
ADJ. EVR
F No. CLOSE
CHART -
MODE CAM
M. EQ. Waveform Monitor
SPEC. FLAT
1. Set the Lens close.
2. Confirm that the WHITE BAL is "PRST".
3. Click the "27. White Shading Offset Adjustment
18dB 12dB" of the camera adjustment software.
4.
5.
6.
7.
8.
9.
FLAT
10. Confirm that the picture on the monitor is FLAT (no
2-29. White Shading Adj.
BOARD CAMDSP Board
ADJ.
F No.
CHART
MODE
M. EQ.
SPEC.
1.
2.
3.
4.
5.
6.
7.
8.
ELE-15
Adjust the slider on the PC so that the waveform
becomes FLAT as shown in 2-26.
Click ">>".
Adjust the slider on the PC so that the waveform
becomes FLAT as shown in 2-26.
Click ">>".
Adjust the slider on the PC so that the waveform
becomes FLAT as shown in 2-26.
Click ">>".
color shading). If the color shading is appeared, adjust
again.
(Standard)
TP VIDEO OUT (75 ohm terminated)
EVR
Adjustment
100% White Chart
CAM
Waveform Monitor, Vector Scope,
Video Monitor
FLAT
Click the "28. White Shading Adjustment Standard"
of the camera adjustment software.
Set the zoom of lens to "160" and adjust focus of lens
so that the output picture is fully white.
Set the Sutter 1/250.
Set the gain of waveform monitor to 5X.
Adjust IRIS of lens so that the white level becomes 70
to 80%.
Operate the "AWB" switch on the front of the Camera.
Click "OK".
Confirm that the waveform and picture on the monitor is
FLAT (no color shading) and the dot of vector scope is
as sown below.
Waveform Monitor (H/V rate)
NG
Vector Scope
OK
NG
OK