Table of Contents
Advertisement
2-21. T1 Loading Arm Unit
Replacement & Adjustment
(Removal)
1.
Remove the cylinder Unit. (Refer to item 2-1)
2.
Move the T1 Post to loading direction by manual
ejecting method until the screw (D) can be
removal position as shown in Figure 2-19.
3.
Unscrew the 2 screws (A) and (C), then remove
the S1 and T1 Post from Loading Rail as shown
in Figure 2-19.
4.
Unscrew the 2 screws (D) and (E), then remove
the Loading Rail as shown in Figure 2-19.
5.
Remove the T1 Loading Arm Unit as shown in
Figure 2-19.
(Installation)
1.
Install the T1 Loading Arm Unit following the
removal steps in reverse order, then Phase
Adjustment should be performed as follows.
(Adjustment)
1.
When install the T1 Loading Arm Unit, then the
hole (A) should match with the hole (B) as shown
in Figure 2-19.
2.
After installation, confirm that the S1 and T1 Post
move smoothly on the Loading Rail.
3.
Perform the T1 Loading Arm Height Adjustment.
(Refer to previous item)
4.
After perform the height adjustment, perform the
Post Height Pre-Adjustment and Tape path
Adjustment.
Note:
This
replacement
simultaneously with replacement of Cylinder Unit.
It is convenient for Replacement of T1 Loading
Arm Unit.
Figure 2-21
should
be
performed
2-22. M-Cassette Brake Base Unit
Replacement
(Camera Recorder only)
(Removal)
1.
Disconnect
P.C.Board.
2.
Unscrew the 4 screws (A) to remove the Servo
P.C.Board as shown in Figure 2-22.
3.
Unscrew the screw (A) to remove the Cassette
Down Photo Unit.
4.
Unscrew
M-Lock/Release Piece Unit.
5.
Unscrew the 2 screws (C) to remove the M
cassette Brake Base Unit. Then pick up the pin of
Eject Arm Unit.
(Installation)
1.
Install the new cassette Brake Base Unit
according to the opposite procedures of
removing.
MECH-49
the
all
connectors
the
screw
(B)
to
Figure 2-22
on
SERVO
remove
the
Advertisement
Chapters
Table of Contents
