2-26. MIC Sensor SW Unit
Replacement
(Camera Recorder only)
(Removal)
1.
Disconnect the connector (A) on the P.C.Board
(A). (Please refer item "7. Table of Connector"
about reference number of connector and name
of P.C.Board.)
Click this button
, then go to item "7. Table of
Connector".
2.
Unscrew the 2 screws (A) and remove the MIC
Base Unit as shown in Figure 2-26.
(Installation)
1.
Install the new MIC Base Unit according to the
opposite procedures of removing.
2.
Confirm that the M cassette touches to MIC Base
Unit properly.
Figure 2-26
2-27. Reel Drive Motor Unit
Replacement
(Studio VTR only)
(Removal)
1.
Disconnect the connector (A) on the P.C.Board
(A). (Please refer item "7. Table of Connector"
about reference number of connector and name
of P.C.Board.)
Click this mark
, then go to item "7. Table of
Connector".
2.
Unscrew the 2 screws (A) and remove the Reel
Drive Sensor P.C.Board as shown in Figure 2-27.
3.
Unscrew the 2 screws (B) and remove the Reel
Drive Motor Unit as shown in Figure 2-27.
(Installation)
1.
Install the new Reel Drive Motor Unit following the
removal step in reverse order.
2-28. L-M Release Angle Unit
Replacement
(Studio VTR only)
(Removal)
1.
Unscrew the 2 screws (A) and remove the L-M
Release Angle Unit as shown in Figure 2-28.
(Installation)
1.
Install the new L-M Release Angle Unit following
the removal steps reverse order.
MECH-54
Figure 2-27
Figure 2-28