2-18. Tension Arm Unit
Replacement
(Removal)
1.
Remove the Cut Washer (A) and hang off the
Tension Regulator Spring, and then remove the
Tension Arm Unit as shown in Figure 2-18.
(Installation)
1.
Install the new Tension Arm Unit following the
removal steps in reveres order.
2.
After installation, Tension Arm Adjustment should
be performed the following steps.
Figure 2-18
<Tension Arm Adjustment Flow Chart>
1-3. Tension Arm Offset Voltage Adjustment
1-4. Tension Arm Neutral Position Adjustment
1-5. Tension Arm PLAY Voltage Adjustment
1-5. Tension Arm REV Voltage
1-6. Tension Regulator Spring Adjustment
1-7. REV Tension Confirmation
MECH-45
START
Confirmation
& Screw Lock
END
NG
NG