Table of Contents
Advertisement
2-23. A/C head Replacement
& Adjustment
<Tools required>
Nut Driver (5.5mm : VFK1150A)
Hex Driver (VFK1148A)
Hex Wrench (VFK1190)
(Removal)
1.
Loosen the hex screw (B) and remove the Nut (C).
Hang off the Head Height Adjustment Spring and
then remove the A/C Head Unit as shown in
Figure 2-23-1.
Point: Memorize height of the Nut (C) before remove
the Nut (C).
Figure 2-23-1
2.
Remove the 2 screws (A) as shown in Figure
2-23-2.
3.
Disconnect the connector (A) on the P.C.Board
(A) and connector (B) on the P.C.Board (B), and
then remove the A/C Head from the A/C Head
Plate as shown in Figure 2-23-2(Please refer item
"7. Table of Connector" about reference number
of connector and name of P.C.Board.).
Click this button
Connector".
4.
Remove the Shield Cover by removing 2 screws
(D) as shown in Figure 2-23-1.
5.
Unsolder the lead wires as shown in Figure
2-23-3. (When unsolder the lead wires, do not
unsolder all at the same time).
MECH-50
, then go to item "7. Table of
Figure 2-23-2
Advertisement
Chapters
Table of Contents
