Secure The Laminator; Use The Bolt-Down Openings - DataCard CR805 Installation And Administrator's Manual

Secure the Laminator

This procedure is optional.
You can secure the laminator using one of the following:
The bolt-down openings in the bottom of the laminator enclosure

An optional cable lock


Use the Bolt-Down Openings

The laminator includes bolt-down openings that you can use to secure the system to a mounting
surface.
You need the following supplies:
The bolt-down kit (part no. 509169-001) contains two M6 well nuts.

Two M6 (6 mm) screws, purchased separately.

The length of the screws you need depends on the thickness of the mounting surface. The
screw length is the surface thickness + 0.75 inch (20 mm).
Two M6 washers, purchased separately.

1/4-inch (7 mm) drill bit.

CR805 Retransfer Card Printer Instrallation and Administrator's Guide A-7