DataCard CR805 Installation And Administrator's Manual page 47

d.
Press E
e.
Press the down arrow to display Network IPv4 on line 2.
f.
Press E
Static IP displays on line 2.
3.
Press E
NTER
displays on line 2.
4.
Set the static IP address, subnet mask, and gateway address.
a.
Press E
displays on line 2.
b.
Press E
The IP address has four sections, separated by periods. A
cursor appears under the digit that will change.
i.
Use the arrow keys to change one digit at a time.
ii.
The address section shows three digits when it can
be changed and the cursor is under the right-most
digit. Press E
the address.
iii.
When all four sections are correct, press E
Subnet Mask displays on line 2 of the LCD panel.
c.
Repeat
mask and gateway address.
CR805 Retransfer Card Printer Installation and Administrator's Guide
to enter the Configuration menu.
NTER
to enter the Network IPv4 menu. DHCP/
NTER
to display the DHCP/Static IP menu. Static IP
to enter the Static IP menu. IP Address
NTER
to set the static IP address.
NTER
to navigate to the next section of
NTER
step b, i through iii, to enter the subnet
.
NTER
31