DataCard CR805 Installation And Administrator's Manual page 112

Hopper1CardImpressPositionOffset2—Set the distance from the trailing edge of the card to

the center of the second impression on the card.
Increase the offset value to increase the distance of the impression from the trailing edge

of the card.
Decrease the offset value to decrease the distance of the impression from the trailing

edge of the card.
Hopper1CardImpressPositionOffset3—Set the distance from the trailing edge of the card to

the center of the third impression on the card.
Increase the offset value to increase the distance of the impression from the trailing edge

of the card.
Decrease the offset value to decrease the distance of the impression from the trailing

edge of the card.
Hopper1CardImpressTemperature—Set the temperature of the impresser punch (in degrees

Celsius).
Increase the value to increase the temperature of the impresser punch.

Decrease the value to decrease the temperature of the impresser punch.

Hopper1CardNumberOfImpresses—Enter the number of impressions to be stamped on the

card. The impresser can stamp up to three impressions in a row on the left, center, or right
part of the card.
ImpresserMaterial—Specify the material on which an impression will be stamped. For

example, you may want to impress directly on the retransfer film without applying an overlay
to the card. The type of material determines the impresser settings used to impress the card.
You can select from the following:
Overlay: The material is a laminate overlay. The impresser uses the Hopper1Card and

ExceptionCard impress settings.
RTM: The material is the retransfer film. The impresser uses different dwell time,

temperature, and depth settings from those used on a laminate overlay.
Make sure that this setting specifies the correct material to be impressed. The job is canceled
and a configuration error is issued if the ImpresserMaterial setting does not match the type
of impress action sent to the laminator (if, for example, ImpresserMaterial=Overlay, but an
overlay is not applied to the card, or ImpresserMaterial=RTM, but an overlay is applied).
Using the wrong temperature can damage the impresser die.
96 Printer Manager