DataCard CR805 Installation And Administrator's Manual page 146

4.
Load the new roll of laminator overlay material.
a.
Put the blue supply spool on the blue supply
spindle of the cartridge (c). The overlay supply roll
can go on only one way and only fits on the
correct spindle.
b.
Put the empty silver take-up spool on the silver
take-up spindle (d).
c.
Turn the take-up spool clockwise to remove slack
from the material (e). The overlay material loads
in an S-shape.
Make sure that the overlay material is between
the guides on both the take-up and supply sides of
the cartridge.
5.
Close the laminator cartridge gate (f). Push it in until
the latch clicks in place (g). Make sure that the
overlay material is not pinched by the cartridge gate.
6.
Replace the loaded laminator cartridge in the printer.
7.
Remove the L2 (orange) cartridge from the laminator,
if installed.
8.
Repeat step 3
the L2 cartridge.
9.
Close and lock the laminator access door.
A-14
through step 6 to load the overlay onto
CLM Laminator