Electrical Requirements; Secure Printing Requirements - DataCard CD Series Installation And Manual

Place the printer away from direct sunlight.
•
Do not place the printer near heating ducts, fans, or other air vents.
•
Do not use the printer for purposes other than the intended use.
•

Electrical Requirements

The ENERGY STAR
within the range stated.
Printer Model
CD800
SD360
The printer is ENERGY STAR‐qualified only when used with the included power
supply.

Secure Printing Requirements

Secure printing consists of encrypting print commands and card data and
transmitting the information securely from the PC to the printer. To use
encryption, your printer must support secure printing. Printers that support
secure printing are shipped with secure printing enabled. Refer to "Behavior
page 42 for more information on using the Printer Manager web service to
specify printer security settings.
When you use the XPS Card Printer Driver, the driver uses the most secure
printing protocol enabled in the printer. For more information, refer to your card
printer's Driver Guide.
If your card production site requires secure printing, use the following:
Datacard SD260L, SD360, or CD800 card printers with secure printing enabled
•
The SD260 and earlier models of SD and CD printers do not support secure printing
and handle only non‐secure printing. You can install a mix of secure and non‐secure
printers, but make sure to connect and install each secure printer to the appropriate
host PC during installation.
A PC that meets the PC requirements cited earlier in this section
•
Ethernet and USB connections that meet the requirements
•
Internet Explorer Version 5.5 or newer installed on the PC
•
4
®
‐rated power supply detects the input voltage and works
Electrical Requirements
110-240V/50-60 Hz/3.0 Amp
" on
Installation