DataCard CR805 Installation And Administrator's Manual page 51

2.
Make sure that the IPv6 manual address method is enabled. Refer to
page 33.
When you enable IPv6 manual addressing, Manual Address
displays on line 2. Press E
address.
3.
Enter the IPv6 address.
An IPv6 address is represented as eight groups of four
hexadecimal digits separated by colons. The address
requires 39 characters to display. Because the LCD is limited
to 16 characters per line, the IPv6 address is spread across
three screens of the LCD. A digit at the end of line 1 indicates
which section of the address is being displayed.
A cursor appears under the digit that will change.
a.
Use the arrow keys to change each hexadecimal digit,
from 0 to F.
b.
Press E
c.
When the address section on the first screen is
complete, press E
address.
4.
When all three sections are correct, press E
line 2.
5.
Press E
NTER
The prefix length indicates the boundary between the
subnet to which the host is connected and the device ID in
the IPv6 manual address. Press the up or down arrow to
change the prefix length.
6.
Press E
NTER
Address on line 2.
CR805 Retransfer Card Printer Installation and Administrator's Guide
to start entering the IP
NTER
to move the cursor to the next digit.
NTER
to display the next section of the
NTER
to view or change the prefix length.
to save your changes and display Gateway
to save the address. Prefix Length displays on
NTER
"Enable IPv6" on
35