Ethernet Requirements; Usb Requirements; Electrical Requirements - DataCard CR805 Installation And Administrator's Manual

Ethernet Requirements

You can connect many network printers to one PC. The maximum number of printers depends on
the capacity of the network to deliver data to the printer.
The following components are required to install a printer on a network:
An Ethernet network that uses the TCP/IP protocol and can run at one of the following:

1Gbase-T (1 gigabyte per second) or 100base-T (100 megabits per second).
An Ethernet cable to connect the printer to the network. An Ethernet cable is not supplied

with the printer.
A PC that meets the

with, the network.

USB Requirements

You can connect up to eight card printers to a PC using USB cables.
To install a printer using a USB connection, the following components are required:
A high-speed USB port. USB 2.0 is required.

A USB cable to connect the printer to the PC. A USB cable is supplied with the printer.

A PC that meets the

If you need to connect two card printers to a PC with one USB port, use a single, independently
powered USB hub to which you can connect both printers.

Electrical Requirements

The power supply detects the input voltage and works within the range stated.
Printer Model
CR805
CR805 with optional
laminator
2
"PC Requirements" on
"PC Requirements" on
Input
85–230VAC/47-63 Hz/1.2Amp
Refer to Appendix A: "CLM
page 1, and is connected to, and communicating
page 1.
Electrical Requirements
24V/6.6Amp/160W
Laminator".
Output
Printer Installation