Inquiries; Operation - ABB PowerValue 11 RT 6 kVA User Manual

• EN-IEC 60950-1. IT equipment. Safety. Part 1: General requirements.
• EN-IEC 62040-2. Uninterruptible power supply (UPS). Part 2: EMC requirements.
The supplier's responsibility is excluded in the event of any modification or intervention in the product by the
customer's side.
Safety
Electromagnetic Compatibility
(EMC)
1.4

Inquiries

Address inquiries about the UPS to the local office or agent authorized by the supplier. Please note the type
code and the serial number of the equipment and contact your nearest agent authorized by the supplier. The
serial number is shown in the nameplate of the product. For further information on troubleshooting, go to
Section 6.
1.5

Operation

Do not remove the enclosure of the UPS. This system is to be serviced by qualified service personnel only.
Do not disconnect the mains cable from the UPS or the building wiring socket during operation as this would
remove the ground to the UPS and of all connected loads.
In order to fully disconnect the UPS, press the OFF-button. Only after the UPS is shutdown, disconnect the
mains load.
To reduce the risk of fire, connect only to a circuit provided with branch circuit overcurrent protection with an
ampere rating in accordance with the IEC/EN 60934 standard or your local electrical code.
Indiscriminate operation of switches may cause output loss or damage to equipment.
This UPS may be connected to a maximum of four External battery enclosures.
Do not dispose batteries on fire as they may explode.
Do not open or mutilate batteries. Released electrolyte is harmful to the skin and eyes.
Product Standards
IEC/EN 62040-1
IEC/EN 62040-2 (C3)
Figure 1: Standards
UPS Breaker
6kVA 40 A
2-pole circuit breaker
10kVA 63 A
2-pole circuit breaker
04-3788_ABB_OPM_PVA11 6-10kVA-RT_EN_140423
Modifications reserved
Standards
IEC/EN 60950-1
IEC/EN 61000-4-2
IEC/EN 61000-4-3
IEC/EN 61000-4-4
IEC/EN 61000-4-5
IEC/EN 61000-4-6
IEC/EN 61000-4-8
IEC/EN 61000-2-2
Page 7/37 ABB