YASKAWA VIPA System 300S+ Manual page 214

+
System specific event IDs VIPA System 300S
Event ID Description
29: The component actively disconnected the system connection to the CPU
31: Inconsistency of the component data base by loading SDB xxxx by the rack component (SDB type
0x3100)
32: Periphery enabled by S7-CPU
33: Periphery disabled by S7-CPU
34: Component STOP due to switch actuation
35: Component STOP due to invalid configuration
36: Component STOP due to PG command
38: SDB xxxx is not registered in the still valid consistency securing object, or it has an incorrect time
stamp (SDB type 0x3107), the error is being corrected
40: Memory reset executed
44: Consistency of the data base achieved after loading the SDBs xxxx by the rack component (SDB type
xxxx)
45: Remanent part of the component data base is deleted by the rack component after being loaded
70: Restore factory defaults (same as memory reset of CPU!)
83: Network interface: automatic configuration, TP/ITP with 10 Mbit/s semi-duplex
96: The MAC address was retrieved from the system SDB. This is the configured address.
97: The MAC address was retrieved from the boot EPROM. This is the factory-provided address.
100: Restart of the component
101: Component STOP due to deletion of system SDBs
104: PG command start was denied due to missing or inconsistent configuration
105: Component STOP due to double IP address
107: Start-up request by switch actuation was denied due to missing or inconsistent configuration
PK: NCM_SERVICE
2: Management
3: Object management system
6: Time synchronisation
10: IP_CONFIG
38: SEND/RECEIVE
214 HB140 | CPU | 317-4PN23 | en | 18-01